Ok, made my cuts. Tried both bevel cuts and just miter cuts. Saw needs just a *little* adjustment. But man it makes it so much faster. I have two frames "clamped' and drying now.
A "single"
A "Double"
Miters are MUCH better now though, and frame fitment is better too:
Trying something new. Instead of a pass through slot, I'm actually taking the front piece where the slot would be off and going to bond it to the acrylic. This should allow for a much easier time sliding it in and out and will allow the acrylic to NOT have a chance of getting scratched on the pass through slot.
A "single"
A "Double"
Miters are MUCH better now though, and frame fitment is better too:
Trying something new. Instead of a pass through slot, I'm actually taking the front piece where the slot would be off and going to bond it to the acrylic. This should allow for a much easier time sliding it in and out and will allow the acrylic to NOT have a chance of getting scratched on the pass through slot.