`
 (Toll Free)
Post Reply 
Share Thread:
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Question about Top Loaders and Penny Sleeves
11-10-2012, 05:58 PM
Post: #1
Question about Top Loaders and Penny Sleeves
This is probably a dumb question but hoping someone can answer because I'm kind've new at this and still learning. When placing a card in a penny sleeve and then putting in a top loader, should the open end of the sleeve be inserted first, so it's at the bottom and completely sealed or is the closed end inserted first?
Find all posts by this user
Quote this message in a reply
11-10-2012, 08:02 PM
Post: #2
RE: Question about Top Loaders and Penny Sleeves
(11-10-2012 05:58 PM)dantanahawaii Wrote:  This is probably a dumb question but hoping someone can answer because I'm kind've new at this and still learning. When placing a card in a penny sleeve and then putting in a top loader, should the open end of the sleeve be inserted first, so it's at the bottom and completely sealed or is the closed end inserted first?

I like the open end of the penny sleeve up towards the open end of the topload. Keeps the bottom of the card more safe.

Photobucket
Find all posts by this user
Quote this message in a reply
11-10-2012, 08:42 PM
Post: #3
RE: Question about Top Loaders and Penny Sleeves
Thanks for the response. I over think things at times. I was just thinking if the open side was down then it would be more protected but I can see your point.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: