Connect With Us!
IOS Store
Post Reply 
Share Thread:
Thread Rating:
  • 1 Votes - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Idea for booklet card holder
07-16-2011, 05:34 PM
Post: #1
Idea for booklet card holder
It's a work in progress but I think it will do the job and look good. The pics are not of the finished product. There is still the protective film on the plexiglass. Just cut the plexiglass enough where there is a border to your liking. Then get some foam sheets. The ones I used are thin so I needed three layers to protect the card. Just cut out a section of the foam sheets to the same dimensions of the plexiglass. Then cut out a section of the foam piece to the size of the card. All I have to do now is put in a few small screws in the corners to hold it down. The picture below is of the side so you can see the thickness and that it completely proctects the card around the edges. Still need to trim the inside edges of the foam. If you want to make one like mine and have a question, just send a message.
[Image: 2011-07-16165945.jpg]
[Image: 2011-07-16170017.jpg]

Find all posts by this user
Quote this message in a reply
Post Reply 

Forum Jump:

User(s) browsing this thread: 1 Guest(s)