[mweber012]

I was offered a Jeter 1/1 printing plate for the Bryce Harper auto relic I have as my sig just the one I have is a plain gray patch though. Should I do this?

[uvaspina]

What year is the Jeter? -Personally, I'd probably hang on to the Harper. If I were you, I'd research the going rate of jeter plates on completed auctions. For most star players, a non-rc plate is usually $40-100 (with super stars on the higher end). Jeter might be double that, but I don't know for sure.

[rmpaq5]

My thought...Harper is listed at the bottom of your posts in your signature as a pc guy, jeter is not. Two While it is a 1/1, if you just want a Jeter plate, any plate, then there are a heck of a lot more out there than just one. I'm not saying it may not be a fair trade in value, just stating what can be observed.

[uvaspina]

id definitely lean toward no.
http://www.ebay.com/sch/i.html?_nkw=jete...=1&_ipg=50

[rmpaq5]

Ok after checking uvaspina's link forget my value comment from the previous post. uhhh....no.

[nyyankeesfan28]

Yeah, keep the Harper. If you want a Jeter printing plate, just buy one, as uvaspina's link shows.

[krn001]

Ok after checking uvaspina's link forget my value comment from the previous post. uhhh....no.

When Jeter has his 3000th hit my 2010 1/1 plate i had went for $100.00, i did have it listed a few times prior in the 125 - 150 range & when i put best offer up is when it sold.
As mentioned above there are many Jeter plates available.

[stera8]

no way!

[Neifert]

i'd say no as well.

[kata78]

Coming from a Jeter collector I would say no.